PeterT

Finally it is working I had to buy a new switch on eBay which turned up yesterday still very confused to what can have caused the whole episode. Thanks to all who responded

Well finally got door panel off tried reset procedure nothing changed. Just to recap drivers window switch will go down but not up. Taken switch apart cannot see any broken bits checked all cables going back to door ECU all fine. Just one question I have do the window buttons have any springs in them to move the white pegs up and down to make contact on the circuit board? I could not see any and was wondering if something was missing. Door panel currently off car on drive 😞

Thank you both will try at the weekend, didn't go down this route previously as thought as window goes up and down when roof open/closed thought it was something else. Will report back

Ill try again on Sunday, thank you

Thanks tried this a few times and no difference, very odd

WIndscreen was replaced, and radiator brackets which were badly corroded. Nothing electrical

Brand New, worked fine when I first installed then had to do some other stuff on car a few months later. Battery is always on trickle charge when car not being used.

The window goes up and down fine when I raise or lower the roof, but cant get it to do the same using the switch. I swapped switches with a friend who has the same car and still did not work so I know its not the switch. Any help appreciated. Thanks Peter

I have same problem, no fault codes showing have swapped discs, pads and actuator rings and made no difference. Would appreciate some guidance

Have decided to replace the dust deflectors as well only £11 each plus VAT from my Lexus Dealer will report back being fitted tomorrow.

ARe front and rear the same? Seem to find lots for rear but not for front, thanks

Have tried to find these in Uk without success https://www.ebay.co.uk/itm/154757762042?mkevt=1&mkcid=1&mkrid=710-53481-19255-0&campid=5338365712&toolid=20006&customid=EB35154027& also do nit seem to make rear right fyi. Am going back to garage Monday and leaving car with them to investigate and also fit new front sensors made by kavo and supplied by autolinkmx5.com both for £60 new.

I took it to a garage to have it done, I will need to check. I am right that there are only rings at the rear?

So as title said replaced rear reluctor rings, disks and pads but still get that pulsating when braking, any help would be appreciate as am planning to get valeted and then garaged till the spring. Thanks in advance

This needs to be fitted back, if I remember it is a support