sebaw

After disconnecting the Battery, parking assist dynamic gridlines not showing. Only information on the screen: "System Initialising" The system required a car steering to the left and right but it did not work. I tried many times.

Solution:
How to enable Service Menu (NX)?
Menu / Screen / Turn off the screen.
Then press on the radio: 5x track forward, 5x track back.

(RX buttons: <CH,  TRACK>)

Steering wheel angle calibration:

Service menu / Function Check-Settings / Camera Settings / Steering Angle Setting / Steering Center Memorize and Max Steering Angle Memorize.

I recently saw new comments. Someone wrote that it is impossible to make changes to the TPMS module via OBDII (you will probably need to disconnect this Chinese module again). I haven't checked it.
But it's good to know.

I marked a screw on my car.

beach - shelf. Yes, that wasn't the best translation.

First necessary to remove the screw of finding in the support that supports the rear range and then remove from the top by pulling the black plastic cover just below the white part (and on which rest the back beach, then the top cover (white) Which protects the speaker easily declipses by pulling on it (no screws). Everything is clipped (except the first and single screw)

You connect the wires of this module from Aliexpress to the T1 module (Receiver assy, Electrical Key & TPMS) - On my NX, the right C-pillar.

See photos in the comment on Aliexpress.This is how I found this module.

I read this thread a few years ago.

____________________________________

I installed this ( https://aliexpress.com/item/4001193377497.html )  module today. NX 200T 2015, German (Luxury-Mark Levinson) version.

It really works 🙂 I now have information about the tire pressure. Not only a low pressure warning.