Camber Adjusters

[Lazyhomer]

does anyone know where or if there is camber adjusters for a is20 as i ned them for my wheels. tyres waering away quite fast

would be really helpful if someone could find a set as iv looked and cant find anything

Ray

[is200_craig]

i think camber is adjustable already how are they wearing? is the car too low?

[JayJay1374]

they do have camber adjustment, is it front or rear? best off getting a 4 wheel alignment done from a garage

[Lazyhomer]

they do have camber adjustment, is it front or rear? best off getting a 4 wheel alignment done from a garage

its wearing on the inside of the tyres at the front and yeah car is pritty low just now

iv put some pictures up on the gallery bit in the is200 & is300 bit. its the orangy red one on the last 2 pages

[Tango]

they do have camber adjustment, is it front or rear? best off getting a 4 wheel alignment done from a garage

its wearing on the inside of the tyres at the front and yeah car is pritty low just now

iv put some pictures up on the gallery bit in the is200 & is300 bit. its the orangy red one on the last 2 pages

It may not just be the camber as the IS200 has major problems with inner tyre wear IF you set the geometry to the original Lexus settings rather than those of WIM. Subject discussed in this link http://www.wheels-in...amber+adjusters

However, if the car is lowered beyond the limit of camber adjustment you need a pair of these.

I had them on the front of my IS250 but they fit the IS200. Fitting of them and of rear camber adjusters discussed here: http://www.wheels-in...adjusters&st=20

[is200_craig]

Do you know how to adjust camber on the standard is200 setup Tango?

[Tango]

Do you know how to adjust camber on the standard is200 setup Tango?

No, I don't.

My IS200 Sport has the standard springs and although it has had the geometry corrected by Tony Bones I wasn't that observant when WIM adjusted the settings to stop the inner tyre wear. The front SPC camber adjusters were fitted to my IS250 because it only had toe adjustment originally and the 35mm drop put the camber outside the acceptable tolerances. The rear camber of the IS250 was still within the Lexus tolerances because the rear was only dropped 25.4mm and the rear camber tolerance is more generous than the front.

If Tony reads this I'm sure he'll advise on the IS200 camber adjustment.