Vsc and abs light

[Mylexrx]

Hi guys , just done front wheel bearings on my o4 2gen rx300 , did nearside first ni probs and the took for a run still all good but a little rumble coming from OSf, so changed it the next day took it for a run great noise all gone smooth as silk .

before I did the bearings , when you pulled up the brakes felt as if the offside was releasing but now works great , pulls up even great , but the ABS andVSC light are on , any ideas 

many thanks mike

[Lager shandy]

You will have to recheck your work you will have damaged or not reconnected the wiring abs sensors etc properly .if no warnings before you touched the brakes 99%of the time it will be your own doing I'm afraid .

[Mylexrx]

There was abit of a prob with osf brake or when coming to a stop it felt like calliper was releasing and rebraking, but no lights so I’m thinking the sensor is faulty any way , because while lights are on and normal brakes working it dosnt do it

[Lager shandy]

I'll think your find abs doesn't work below say 3-5 mph .did you check your calliper sliders for binding doing the repair. Any damage to the sensor gear or bracket try checking the sensor resistance with the other side .

[Mylexrx]

Had it all apart doing wheel bearings , and cleaned everything, there was a lot of like iron filings on both sensors when I cleaned them , but I will check resistance 

thanks